Mr. Gasket 6026 CARBURETOR,LINKAGE BUSHING
Fits Carburetor Throttle Levers with 1/2 Inch Hole - Fits 1/4 Inch Bolt (Inside Diameter).
This Carburetor Bushing Kit reduces the 1/2 inch throttle shaft hole to 1/4 inch i.d., (inner diameter) which makes for easy throttle linkage attachment, or can be used to replace the stock rubber unit. Machined from cold roll steel, then bright zinc plated, the two piece bushing measures 9/16 inch wide when installed and fits most 4-barrel carburetors with 1/2 inch throttle linkage hole. Application: All GM (General Motors) and most Holley Carburetors with 1/2 inch diameter throttle hole.
  • 1/4" Inside Diameter - fits 1/4" Bolt
  • Fit Throttle Linkage w/ 1/2" Hole

Information:

Holley Performance Emission Code 5: This part is legal for sale or use on Emissions Controlled Vehicles; Uncontrolled (Non-Emissions Controlled) Vehicles; and Racing Use Only Vehicles because it does not affect vehicle emissions and is not covered by emissions regulations
Attributes
ASIN B000BWAPHK
Brand Mr. Gasket, Mr. Gasket
California Proposition 65 No
Category Air and Fuel Delivery
Country of Origin (Primary) US
Emission Code 5, 5
GTIN 00084041060261
Harmonized Tariff Code (Schedule B) 8302303060
Hazardous Material Code N
Inside Diameter 0.250 in., .25"
Item Weight 0.060 lbs.
Life Cycle Status Code Available to Order
NAFTA Preference Criterion Code B
Outside Diameter 0.625 in., .625"
Product Type Throttle Lever Bushing, Throttle Lever Bushing
SDR Required Flag N
Sub Category Carburetion
Warning California Proposition 65, California Proposition 65
Warranty Limited 90 Day, Manufacturer's Limited 90 Day Warranty
Weight 0.06, 0.0600
part type Carburetor Accelerator Linkage Kit

Write a review.

Note: HTML is not translated.
    Bad           Good

Mr. Gasket 6026 CARBURETOR,LINKAGE BUSHING

Product Information

Call for Pricing

Vehicle Fitment

SunMonTueWedThuFriSat
293012345678910111213141516171819202122232425262728293031123456789
:
PM