1-3/8 Inch Long
Mr. Gasket Short Carburetor Studs put an end to stripped-out threads in cast aluminum manifolds, holding the gasket in place and perfectly aligning the carburetor in position. Zinc-plated and 1-3/8 inch long, they have 5/16-18 threads on one end and 5/16-24 on the other, come in a package of four, and have four matching nuts and washers to complete the job.
  • Puts an end to stripped-out threads in cast aluminum manifolds
  • Holds the gasket in place and perfectly aligns the carburetor in position
  • Zinc-plated and 1.375 inches long with 5/16 coarse threads on one end and 5/16 fine threads on the other
  • Package of four with four matching nuts and washers

Information:

Holley Performance Emission Code 5: This part is legal for sale or use on Emissions Controlled Vehicles; Uncontrolled (Non-Emissions Controlled) Vehicles; and Racing Use Only Vehicles because it does not affect vehicle emissions and is not covered by emissions regulations
Attributes
ASIN B000BWAOCG
Brand Mr. Gasket
California Proposition 65 No
Category Air and Fuel Delivery
Country of Origin (Primary) CN
Emission Code 5
Finish Zinc
GTIN 00084041000595
Harmonized Tariff Code (Schedule B) 7318158065
Hazardous Material Code N
Item Weight 0.190 lbs.
Life Cycle Status Code Available to Order
Material Steel
NAFTA Preference Criterion Code B
Product Type Carburetor Studs
SDR Required Flag N
Sale Category Air and Fuel Delivery
Sub Category Hardware, Fasteners and Fittings
Warning California Proposition 65
Warranty Limited 90 Day, Manufacturer's Limited 90 Day Warranty
Weight 0.19, 0.1900
part type Carburetor Throttle Stud

Write a review.

Note: HTML is not translated.
    Bad           Good

Mr. Gasket 59 CARB STUDS 1-3/8 LENGTH

Product Information

Call for Pricing

Vehicle Fitment

0 reviews  /  Write a review.